Introduction

Jecod 'Professional' Range DCP Pumps

These new pumps improve on the previous DCP pump design as follows:

Sine Wave controller technology provides super quiet operation
New Digital Controller- Speed Control Settings Between 30%-100% in 1 Watt increments (DCP4000 and DCP2500 has an 8 speed controller)
Digital display of power consumption.
Suitable for external and internal operation
Seals for input and output connections
Improved Head Pressure Performance over DCP Models
New Enclosed Impeller Design For a more Quiet Operation
Energy Saving up to 65%
IC Electronic Detection- Automatic Power Off Protection Upon No Water
Wear Resistant Ceramic Shaft

Features

DCP-2500 (23W)

Maximum flow rate of up to 2,500 litres/hour - adjustable from 750 - 2,500 litre/hour ( in 8 steps )

DCP-4000 (33W)

Maximum flow rate of up to 4,000 litres/hour - adjustable from 1,200 - 4,000 litres per hour ( in 8 steps ).

DCP-6500 (55W)

Maximum flow rate of up to 6,500 litres/hour - adjustable from 1,950 - 6,000 litres per hour in 1W steps.

DCP-8000 (65W)

Maximum flow rate of up to 8,000 litres/hour - adjustable from 2,400 - 8,000 litres per hour in 1W steps.

DCP-10000 (80W)

Maximum flow rate of up to 10,000 litres/hour - adjustable from 3,000 - 10,000 litres per hour in 1W steps.

DCP-15000 (105W)

Maximum flow rate of up to 15,000 litres/hour - adjustable from 4,500 - 15,000 litres per hour in 1W steps.

DCP-18000 (145W)

Maximum flow rate of up to 18,000 litres/hour - adjustable from 5,400 - 18,000 litres per hour in 1W steps.

DCP-20000 (170W)

Maximum flow rate of up to 20,000 litres/hour - adjustable from 8,000 - 20,000 litres per hour in 1W steps.

Electronic detection of no water enables automatic power off protection
Motor protection if rotor is blocked
Can be used in Marine and Freshwater applications
No copper elements
Long operation life is achieved by the use of wear resistant ceramic shaft
Soft start operation - pump gradually builds up to set flow rate
Feed mode disables pump for 10 minutes
Speed settings (30% - 100%) in 1Watt (or 8 steps for DCP 2500/4000) steps with power consumption indication - setting is retained if power is lost.